Zigduino TODO
Struck-through items have been committed to hardware
Italicized items have been committed to the appropriate source files
Release 1
Spin 2
- Ground CLKI pin
- Remove R2
Spin 3
- Correct pin 11 silkscreen
Release 2
- Replace FTDI chip with Atmega 8u2, ala UNO
- Switch UART0 to USB only
- Connect pins 0/1 to UART1
- Switch digital pins to level shifters
- Add auxiliary UART0 connector
- Bring UART1 out to digital pins 0/1
- Switch from edge-mounted RPSMA to vertical MMCX
- Switch to surface-mount barrel jack
- Bring out all unused I/O pins to secondary header(s)
- Move reset switch to the edge, change to right angle
- Correct power plug hole spacing (is 6.1mm, should be 4.5mm)
- Add pads for RTC crystal
- Add fourth mounting hole to match the Uno
- Add extra I2C header pins, IOREF pin to match the Leonardo etc
- Fix the silkscreen
page revision: 6, last edited: 27 Sep 2011 04:47